Salvaging Diskette Data

written by: Grace Nelson; article published: year 2006, month 12;



In: Categories » Computers and technology » Storage devices » Salvaging Diskette Data

If a diskette is physically damaged, you may be able to salvage the data by removing the actual diskette medium from its protective sheath. For a 5.25-inch diskette, take the following steps, which we've used successfully more than once:

Use a razor blade or sharp knife carefully to trim about 1/8 of an inch (3 mm) from the bottom edge of the protective sheath of another diskette that you don't care about. The bottom edge is that nearest the drive door when the diskette is inserted into the drive.

Gently squeeze the two edges adjoining the trimmed edge toward the center to open a gap in the trimmed edge. Grasp the plastic medium and gently slide it out of the sheath, leaving the Tyvek inner liner in place. Discard the medium and save the sheath.

Repeat the first step on the damaged diskette, and then remove the medium, touching it as little as possible. Put your finger in the central hub hole and gently press the medium toward the trimmed edge. If you must grasp the medium itself, do so only at the very edge. Be very careful not to bend or deform the medium while you are extracting it.

Gently slide the medium from the damaged diskette into the new sheath that you previously prepared, making sure that the medium is right-side up, fully inserted, and that the hub hole in the medium is centered in the hub hole on the sheath. Rotate the medium gently by using your finger in the hub hole to ensure that it turns easily.

Insert the patched diskette into the drive and attempt to access it. It's not necessary to tape or otherwise secure the trimmed edge. If you can access some or all of the data on the patched diskette, immediately copy it elsewhere and then discard the diskette.

Salvaging data from a 3.5-inch diskette is usually impossible. Any damage that renders the hard plastic shell unusable normally also destroys the medium that it contains. However, if recovering the data is critical, you can attempt the following steps, which we've had much less luck with:

Locate a 3.5-inch diskette of the same type (DD, HD, or ED) as the damaged diskette that you are willing to destroy. Using a nail file or small screwdriver, gently pry the sliding metal shutter off the diskette and discard the shutter.

Gently pry open the shell. Remove and discard the medium, leaving the two Tyvek inner liners in place. Place the shell aside.

Repeat the first step on the damaged diskette, and then remove the medium, touching it as little as possible. If the medium is visibly damaged, as it probably will be, continuing is likely to be useless. However, we did once succeed in recovering some files from a medium that appeared to be severely damaged, so it may be worth the effort.

Place the medium from the damaged diskette into the new shell you prepared, making sure to orient the medium as it was in the original diskette, and snap the shell closed. Use your fingertip to make sure that the medium turns freely within the shell. Insert the repaired diskette into the drive (you need not replace the shutter first) and attempt to read the diskette.

legal disclaimer

1) Our website is not responsible for the information contained by this article as well for any and all copyright infringements by authors and writers. E-articles is a free information resource. If you suspect this article for any copyright infringements, please read the Terms of service and contact us to investigate the problem.
2) The E-articles directory team is not responsible for inaccuracies, falsehoods, or any other types of misinformation this tutorial may contain and will not be liable for any loss or damage suffered by a user through the user's reliance on the information gained here. Please read the Terms of service

Useful tools and features

Translate this article to...    Send this article to you or to a friend

Link to this article from your page   
If you like this article (tutorial), please link to it from your web page using the information above. Linking to this page, this is the only way to help us improve our service, the same time providing your visitors with a way to improve their online experience.

related articles

1. High Capacity Magnetic Storage Devices
High-capacity removable media drives are an ever-shrinking category. With competition at the low end (1GB and under capacities) from USB flash memory keychain drives and at higher capacities from external mini-hard disks (4GB and up), rewritable DVD (8.5GB), and larger USB and FireWire hard disks (20GB and up), there are only two current product families, both from Iomega: Zip. Flexible media, with capacities of 100MB, 250MB, and 750MB REV. Rigid media, with capacity of 35GB (native...

2. Handling CD Read Errors
Handling errors when reading a disc was a big part of the original Red Book CD standard. CDs use parity and interleaving techniques called cross-interleave Reed-Solomon code (CIRC) to minimize the effects of errors on the disk. This works at the frame level. When being stored, the 24 data bytes in each frame are first run through a Reed-Solomon encoder to produce a 4-byte parity code called "Q" parity, which then is added to the 24 data bytes. The resulting 28 bytes are then run though another encoder that uses a different scheme...

3. Floppy Drive Types
As distinct from diskette types and formats, six drive types have been installed in PC-compatible systems: 5.25-inch 160/180 KB (SSDD) Single-Sided, Double-Density(SSDD) was the standard FDD in very early PC-class systems. These drives read and write only SSDD diskettes. 5.25-inch 320/360 KB (DSDD) Double-Sided, Double-Density(DSDD) was the standard FDD in PC-class systems, and was often found as a second FDD in early AT and 386 systems. The...

4. How to choose a Tape Backup Drive
Choosing a tape backup drive can be a simple job if you need to back up a single standalone system with a relatively small hard drive. The decision becomes more complex if the system has a larger hard drive or if you must back up a desktop system as well as a laptop. Choosing a tape backup drive type can be an even more complex program if you must back up a network server's hard drives and perhaps even back up the workstations from the server. As you ponder which backup tape drive you should select, consider the following facto...

5. DVD Copy Protection
DVD video discs employ several levels of protection that are mainly controlled by the DVD Copy Control Association (DVD CCA) and a third-party company called Macrovision. This protection typically applies only to DVD-Video discs, not DVD-ROM software. So, for example, copy protection might affect your ability to make backup copies of The Matrix, but it won't affect a DVD encyclopedia or other software application distributed on DVD-ROM discs. Note that every one of these protection systems has been broken, so with a lit...

6. How to Manually Resolve Motherboard Conflicts
In the past, the only way to resolve conflicts manually was to take the cover off your system and start changing switches or jumper settings on the adapter cards. Fortunately, this is a bit easier with plug-and-play because all the configuration is done via the Device Manager software included in the operating system. Although some early plug-and-play cards also had jumper switches or setup options to enable them to be configured manually, this feature was found primarily on ISA PnP-compatible cards. Be sure you write down or print o...

7. Hard Drive Advancements
In 1957, Cyril Northcote Parkinson published his famous compilation of essays titled Parkinson's Law, which begins with the statement, "Work expands so as to fill the time available for its completion." A corollary of Parkinson's most famous "law" can be applied to hard drives: "Data expands so as to fill the space available for its storage." This, of course, means that no matter how big a drive you get, you will find a way to fill it. I know that I have lived by that dictum since purchasing my first hard disk drive more than 2...