Manufacturing process for data CD ROM and audio CD

written by: Terry McLean; article published: year 2006, month 12;


In: Root » Computers and technology » Storage devices » Manufacturing process for data CD ROM and audio CD

Dutch French Spanish Portuguese Italian German Japanese Chinese Korean Russian Arabic Bookmark and Share this Article

Commercial mass-produced CDs are stamped or pressed and not burned by a laser as many people believe. Although a laser is used to etch data onto a glass master disc that has been coated with a photosensitive material, using a laser to directly burn discs would be impractical for the reproduction of hundreds or thousands of copies

The steps in manufacturing CDs are as follows:

1.
Photoresist Coating. A circular 240mm diameter piece of polished glass 6mm thick is spin-coated with a photoresist layer about 150 microns thick and then hardened by baking at 80°C (176°F) for 30 minutes.
2.
Laser Recording. A Laser Beam Recorder (LBR) fires pulses of blue/violet laser light to expose and soften portions of the photoresist layer on the glass master.
3.
Master Development. A sodium hydroxide solution is spun over the exposed glass master, which then dissolves the areas exposed to the laser, thus etching pits in the photoresist.
4.
Electroforming. The developed master is then coated with a layer of nickel alloy through a process called electroforming. This creates a metal master called a father.
5.
Master Separation. The metal master father is then separated from the glass master. The father is a metal master that can be used to stamp discs, and for short runs, it may in fact be used that way. However, because the glass master is damaged when the father is separated, and because a stamper can produce only a limited number of discs before it wears out, the father often is electroformed to create several reverse image mothers. These mothers are then subsequently electroformed to create the actual stampers. This enables many more discs to be stamped without ever having to go through the glass mastering process again.
6.
Disc Stamping Operation. A metal stamper is used in an injection molding machine to press the data image (pits and lands) into approximately 18 grams of molten (350°C or 662°F) polycarbonate plastic with a force of about 20,000psi. Normally, one disc can be pressed every 23 seconds in a modern stamping machine.
7.
Metalization. The clear stamped disc base is then sputter-coated with a thin (0.050.1 micron) layer of aluminum to make the surface reflective.
8.
Protective Coating. The metalized disc is then spin-coated with a thin (67 micron) layer of acrylic lacquer, which is then cured with UV (ultraviolet) light. This protects the aluminum from oxidation.
9.
Finished Product. Finally, a label is affixed or printing is screen-printed on the disc and cured with UV light.

This manufacturing process is identical for both data CD-ROMs and audio CDs.

Disclaimer

1) E-articles is not responsible for the information contained by this article as well for any and all copyright infringements by authors and writers. E-articles is a free information resource. If you suspect this article for any copyright infringement, please read the terms of service and contact us to investigate the problem.
2) E-articles is not responsible for inaccuracies, falsehoods, or any other types of misinformation this article may contain and will not be liable for any loss or damage suffered by a user through the user's reliance on the information gained here.

link to this article