In: Categories » Electronics and communication » Protocols » Limitations of IPv4
|
The current version of IP (known as version 4 or IPv4) has not changed substantially since Request for Comments (RFC) 791, which was published in 1981. IPv4 has proven to be robust, easily implemented, and interoperable. It has stood up to the test of scaling an internetwork to a global utility the size of today’s Internet. This is a tribute to its initial design. However, the initial design of IPv4 did not anticipate the following: ■ The recent exponential growth of the Internet and the impending exhaustion of the IPv4 address space Although the 32-bit address space of IPv4 allows for 4,294,967,296 addresses, previous and current allocation practices limit the number of public IPv4 addresses to a few hundred million. As a result, public IPv4 addresses have become relatively scarce, forcing many users and some organizations to use a NAT to map a single public IPv4 address to multiple private IPv4 addresses. Although NATs promote reuse of the private address space, they violate the fundamental design principle of the original Internet that all nodes have a unique, globally reachable address, preventing true end-to-end connectivity for all types of networking applications. Additionally, the rising prominence of Internet-connected devices and appliances ensures that the public IPv4 address space will eventually be depleted. ■ The need for simpler configuration Most current IPv4 implementations must be either manually configured or use a stateful address configuration protocol such as Dynamic Host Configuration Protocol (DHCP). With more computers and devices using IP, there is a need for a simpler and more automatic configuration of addresses and other configuration settings that do not rely on the administration of a DHCP infrastructure. ■ The requirement for security at the Internet layer Private communication over a public medium such as the Internet requires cryptographic services that protect the data being sent from being viewed or modified in transit. Although a standard now exists for providing security for IPv4 packets (known as Internet Protocol security, or IPsec), this standard is optional for IPv4 and additional security solutions, some of which are proprietary, are prevalent. ■ The need for better support for prioritized and real-time delivery of data Although standards for prioritized and real-time delivery of data—sometimes referred to as Quality of Service (QoS)—exist for IPv4, real-time traffic support relies on the 8 bits of the historical IPv4 Type of Service (TOS) field and the identification of the payload, typically using a User Datagram Protocol (UDP) or Transmission Control Protocol (TCP) port. Unfortunately, the IPv4 TOS field has limited functionality and, over time, has been redefined and has different local interpretations. The current standards for IPv4 use the TOS field to indicate a Differentiated Services Code Point (DSCP), a value set by the originating node and used by intermediate routers for prioritized delivery and handling. Additionally, payload identification that uses a TCP or UDP port is not possible when the IPv4 packet payload is encrypted. To address these and other concerns, the Internet Engineering Task Force (IETF) has developed a suite of protocols and standards known as IP version 6 (IPv6). This new version, previously called IP-The Next Generation (IPng), incorporates the concepts of many proposed methods for updating the IPv4 protocol. IPv6 is designed intentionally to have minimal impact on upper- and lower-layer protocols and to avoid the random addition of new features.
|
legal disclaimer
1) Our website is not responsible for the information contained by this article as well for any and all copyright infringements by authors and writers. E-articles is a free information resource. If you suspect this article for any copyright infringements, please read the Terms of service and contact us to investigate the problem.
2) The E-articles directory team is not responsible for inaccuracies, falsehoods, or any other types of misinformation this tutorial may contain and will not be liable for any loss or damage suffered by a user through the user's reliance on the information gained here. Please read the Terms of service
Useful tools and features
If you like this article (tutorial), please link to it from your web page using the information above. Linking to this page, this is the only way to help us improve our service, the same time providing your visitors with a way to improve their online experience.
related articles
The first goal is detection. Can we tell when someone powers on a card within range of the local network? This can be done with off-the-shelf components and free software. The Cisco Aironet driver included with the more recent Linux kernels supports "RF Monitor" mode, which permits promiscuous monitoring of 802.11 packets - specifically, monitoring raw 802.11 frames to detect if there are any telltale frames broadcast by a rogue access point or card. As outlined in the original 802.11 specification, ther...
|
|
The HTTP protocol can be likened to a conversation based on a series of questions and answers, which we refer to respectively as HTTP requests and HTTP responses. The contents of HTTP requests and responses are easy to read and understand, being near to plain English in their syntax. This section examines the structure of these requests and responses, along with a few examples of the sorts of data they may contain. The HTTP Request After opening a connection to the intended serv...
3. INFRASTRUCTURE PROTOCOLS AND APPLICATIONS
H.323 H.323 defines packet standards for terminal equipment and services for multimedia communications over local and wide area networks communicating with systems connected to telephony networks such as ISDN. The initial version of this standard came from the International Telecommunications Union (ITU) in June 1996. It defines communication over IP-based local area networks (LANs). A later version (v2), adopted in January 1998, extended it over wide are...
4. Wireless IN Services
The IN protocols and concepts can be used to implement enhanced wireless services rapidly and to have these services available across serving areas in an untethered wireless network. Some of these services are listed below: Voice-Based User Identification. This service employs a form of automatic speech recognition to validate the identity of the speaker. Access to services can then be restricted to the user whose voice (phrase) has been used to train the recognition device. Voice-Based Featur...
5. Wireless LAN and Personal Area Network
The Wireless Internet is not just wireless communications across town or the country. It is also local—sometimes in a home or office building. Wireless LANs are just becoming popular with economically priced wireless Ethernet equipment. Standards such as IEEE 802.11, HiperLAN2, and Home RF are leading the way to untethered communications in-building or outside over small areas. Another important development is the Personal Area Network, also known as Bluetooth. Let’s take a look at each of th...
6. The Domain Concept
The solution to all of these problems is the network domain. In a domain, you only have a single name and password, which gets you into every shared PC and printer on the network. Everyone's account information resides on a central computer called a domain controllera computer so important, it's usually locked away in a closet or a data-center room. A domain controller keeps track of who is allowed to log on, who is logged on, and what each person is allowed to do on the network. When you log onto the domain with your PC,...
7. Duplexing Techniques in Wireless communication systems
Wireless communication systems have evolved through several stages of multiple-access control. The foremost controllable resource has always been the frequency spectrum. Other resources such as time, code, and space were initially manipulated in a very precarious and, therefore, ineffective manner. The early systems operated in the simplex mode in the forward link. Halfduplex systems soon appeared, in which forward link and reverse link shared the same channel. Access control was performed on a push-to-talk basis wit...
8. Wireless Networks (WiFi or 802.11)
Millions of people, have embraced the flexibility of a networking system that involves no wires at alla cordless networking technology called WiFi or 802.11 ("eight-oh-two dot eleven"). (Your Macintosh friends probably call the same thing AirPort, because that's what Apple calls it.) To get onto a wireless network, your PC needs a WiFi transmitter. Almost every laptop sold today has WiFi built in. You can also add it to a desktop in the form of a wireless card or USB adapter; either way, you gain a little antenna. Once...
9. VPN and Tunneling Protocols
Let us discuss the most common and widely used real-world VPN protocols. The growing number of users, the ease of accessibility, and the reduced cost of the Internet connection have introduced a greater need for cost-effective and secure communications without purchase of leased lines. Many companies participated in the development that resulted in the creation of different VPN standards and protocols. We discuss the most common ones here. IPSec IPSec is the most widely acknowledged, supported, and standardize...