In: Categories » Computers and technology » Memory Processor Motherboards and buses » EDORAM ~ Extended Data Out RAM
|
In 1995, a newer type of memory called extended data out (EDO) RAM became available for Pentium systems. EDO, a modified form of FPM memory, is sometimes referred to as Hyper Page mode. EDO was invented and patented by Micron Technology, although Micron licensed production to many other memory manufacturers. EDO memory consists of specially manufactured chips that allow a timing overlap between successive accesses. The name extended data out refers specifically to the fact that unlike FPM, the data output drivers on the chip are not turned off when the memory controller removes the column address to begin the next cycle. This enables the next cycle to overlap the previous one, saving approximately 10ns per cycle. The effect of EDO is that cycle times are improved by enabling the memory controller to begin a new column address instruction while it is reading data at the current address. This is almost identical to what was achieved in older systems by interleaving banks of memory, but unlike interleaving, with EDO you didn't need to install two identical banks of memory in the system at a time. EDO RAM allows for burst mode cycling of 5-2-2-2, compared to the 5-3-3-3 of standard fast page mode memory. To do four memory transfers, then, EDO would require 11 total system cycles, compared to 14 total cycles for FPM. This is a 22% improvement in overall cycling time, but in actual testing, EDO typically increases overall system benchmark speed by about 5%. Even though the overall system improvement might seem small, the important thing about EDO was that it used the same basic DRAM chip design as FPM, meaning that there was practically no additional cost over FPM. In fact, in its heyday, EDO cost less than FPM and yet offered higher performance. EDO RAM was ideal for systems with bus speeds of up to 66MHz, which fit perfectly with the PC market up through 1997. However, since 1998 with the advent of faster system bus speeds (100MHz and above), the market for EDO has rapidly declined as the newer and faster SDRAM architecture has become the standard for new PC system memory. A variation of EDO is burst EDO (BEDO). BEDO is basically EDO memory with special burst features for even speedier data transfers than standard EDO. Unfortunately, the technology was owned by Micron and not a free industry standard, so only one chipset (Intel 440FX Natoma) ever supported it. BEDO was therefore quickly overshadowed by industry-standard SDRAM, which was favored among PC system chipset and system designers over proprietary designs. As such, BEDO never really saw the light of production, and to my knowledge no systems ever really used it.
|
legal disclaimer
1) Our website is not responsible for the information contained by this article as well for any and all copyright infringements by authors and writers. E-articles is a free information resource. If you suspect this article for any copyright infringements, please read the Terms of service and contact us to investigate the problem.
2) The E-articles directory team is not responsible for inaccuracies, falsehoods, or any other types of misinformation this tutorial may contain and will not be liable for any loss or damage suffered by a user through the user's reliance on the information gained here. Please read the Terms of service
Useful tools and features
If you like this article (tutorial), please link to it from your web page using the information above. Linking to this page, this is the only way to help us improve our service, the same time providing your visitors with a way to improve their online experience.
related articles
These systems are excellent candidates for memory upgrades. Early Pentium II systems often have only 16 MB of RAM. In the price-sensitive consumer Celeron market, many early systems shipped with only 16 MB, and some Celeron systems have been sold with only 8 MB. Expanding memory to 128 MB or more is the most cost-effective upgrade you can make. When upgrading memory in one of these systems, note the following issues: Some early Pentium II and Celeron systems use EDO SIMMs or DIMMs, but most use 3.3 volt...
2. Troubleshooting Memory
Memory problems can be difficult to troubleshoot. For one thing, computer memory is still mysterious to people because it is a kind of "virtual" thing that can be hard to grasp. The other difficulty is that memory problems can be intermittent and often look like problems with other areas of the system, even software. This section shows simple troubleshooting steps you can perform if you suspect you are having a memory problem. To troubleshoot memory, you first need some memory-diagnostics testing programs. You already have several, a...
3. How SIMM DIMM and RIMM memory work
Originally, systems had memory installed via individual chips. They are often referred to as dual inline package (DIP) chips because of their designs. The original IBM XT and AT had 36 sockets on the motherboard for these individual chips; then more of them were installed on the memory cards plugged into the bus slots. I remember spending hours populating boards with these chips, which was a tedious job. Besides being a time-consuming and labor-intensive way to deal with memory, DIP chips had one notorious problemthey crept out of th...
4. The evolution of Microprocessors from 1971 to the Present
It is interesting to note that the microprocessor had existed for only 10 years prior to the creation of the PC! Intel invented the microprocessor in 1971; the PC was created by IBM in 1981. Now more than 20 years later, we are still using systems based more or less on the design of that first PC. The processors powering our PCs today are still backward compatible in many ways with the 8088 that IBM selected for the first PC in 1981. November 15, 2001 marked the 30th anniversary of the microprocessor, and in those 30 years processor ...
5. RDRAM
Rambus DRAM (RDRAM) is a fairly radical memory design found in high-end PC systems from late 1999 through 2002. Intel signed a contract with Rambus in 1996 ensuring it would support RDRAM into 2001. After 2001, Intel continued to support RDRAM in existing systems, but new chipsets and motherboards primarily shifted to DDR SDRAM, and all future Intel chipsets and motherboards are being designed for either conventional DDR or the newer DDR2 standard. RDRAM standards had been proposed that will support faster processors through 2006; however, w...
6. Processor Codenames
Intel, AMD, and Cyrix have always used codenames when talking about future processors. The codenames usually are not supposed to become public, but they typically do. They can often be found in online and print news and magazine articles talking about future-generation processors. Sometimes, they even appear in motherboard manuals because the manuals are written before the processors are officially introduced. Processor Coden...
7. What is UMA ~ Upper Memory Area
The term Upper Memory Area (UMA) describes the reserved 384KB at the top of the first megabyte of system memory on a PC/XT and the first megabyte on an AT-type system. This memory has the addresses from A0000 through FFFFF. The way the 384KB of upper memory is used breaks down as follows: The first 128KB after conventional memory is called video RAM. It is reserved for use by video adapters. When text and graphics are displayed onscreen, the data bits that make up those images reside in this space. Video RAM is allotted t...
8. Memory Basics ~ ROM DRAM SRAM Cache Memory
Memory is the workspace for the computer's processor. It is a temporary storage area where the programs and data being operated on by the processor must reside. Memory storage is considered temporary because the data and programs remain there only as long as the computer has electrical power or is not reset. Before being shut down or reset, any data that has been changed should be saved to a more permanent storage device (usually a hard disk) so it can be reloaded into memory in the future. Memory often is called RAM, for random acce...
9. What are Dual Core Processors. Advantages of Dual Core Processor
No matter how fast a conventional single-core processor operates or how much RAM is installed in a system, it must ensure that each program and process that is running is properly serviced. As more and more programs are opened, the amount of time the processor can devote to each program is reduced. The result is that system performance declines. Workstations and servers have long enjoyed the benefits of multiple processors, including better responsiveness when multitasking, faster performance in single multithreaded applications, and better ...
10. How to install RAM Upgrades
Adding memory to a system is one of the most useful upgrades you can perform and also one of the least expensiveespecially when you consider the increased capabilities of Windows 9x/Me, Windows NT/2000/XP, and Linux when you give them access to more memory. In some cases, doubling the memory can practically double the speed of a computer. The following sections discuss adding memory, including selecting memory chips, installing memory chips, and testing the installation. Upgrade Options and Strategies...